基于VB的数控车削加工仿真系统的研究与开发*

作者：张少伍1，韩 江2，胡慧萍1 日期：2007-12-28/span> 浏览：3178 查看PDF文档

基于VB的数控车削加工仿真系统的研究与开发*
张少伍1，韩 江2，胡慧萍1
（1.铜陵学院 机械工程系，安徽 铜陵 244000; 2.合肥工业大学 机械与汽车工程学院，安徽 合肥 230009）

摘 要：针对高校数控教学与培训的实际情况，利用Visual Basic 6.0开发出数控车床加工仿真系统，阐述了仿真系统设计的基本框架和几个关键技术的处理。经过实例验证，该系统运行效果良好，应用方便，完全能够满足教学和培训要求，具有广阔的开发应用前景。
关键词：数控；仿真系统；插补；校验

Research and development on simulation system of NC turning based on VB
ZHANG Shaowu1, HAN Jiang2, HU Huiping1
(1.Department of Mechanical Engineering, Tongling College, Tongling 244000, China;
2.College of Mechanical & Auto Engineering, Hefei University of Technology, HeFei  230009, China)

Abstract: The simulation system of NC turning was designed by Visual Basic 6.0, aimed on the actual faction of education and training. The basic frame and the key technologies about the simulation systems design were introduced. An example verifies that the system is very useful and convenient to learner, which can contents demands for education and training completely, and it illustrates a good prospect of application and extension.
Key words: numerical control; simulation system; interpolation; verify