一种升压型白光LED驱动控制芯片的设计*

作者：李帆，吴晓波 日期：2008-12-26/span> 浏览：3827 查看PDF文档

一种升压型白光LED驱动控制芯片的设计*

李帆，吴晓波
（浙江大学 超大规模集成电路研究所,浙江 杭州 310027）

摘要：针对高亮度白光LED的驱动要求，提出了一种适用于升压型LED驱动电路控制器的设计方案。针对LED的电气特性，芯片控制策略采用峰值电流模式控制并建立了小信号模型进行系统环路补偿设计；针对LED的背光应用要求，在控制器中集成了模拟与数字调光功能，具体介绍了数字调光模式的功能电路，其最大的调光比可以达到3 000w1。为了满足更高的效率要求，设计了无采样电阻的控制电路，减少了外围的器件并提高了系统的效率。芯片在1.5 μm BCD工艺下设计并流片，最后进行了各种工作模式下的测试。测试结果显示，该芯片基本满足设计要求。
关键词：升压型LED驱动控制器；峰值电流模式；PWM调光；BCD工艺
中图分类号：TN433文献标识码：A文章编号：1001-4551(2008)11-0005-04

Design of a Boost WLED driver controller IC
LI Fan, WU Xiaobo
(Institute of Very Large Scale Integrated Circuit Design, Zhejiang University, Hangzhou 310027, China)
Abstract: An integrated circuit(IC)controller for Boost converter was proposed. The controller could be applied to Stepup(Boost)topology, especially for high light LED driver circuit. According to the characteristics of LED, the peak current mode control strategy with slope compensation was adopted and establish the small signal model to design compensation network for whole system. To meeting the demands of LED back lighting, the digital and analog dimming circuits were integrated onto the chip, the PWM dimming function circuits were introduced and the maximum dimming ratio was up to 3 000w1. In addition, a no sense resistor mode was introduced into the circuit, which results in reducing the peripheral components and enhancing the system efficiency. The controller was designed and fabricated in 1.5 μm BCD process and the different modes test results are consistent with design specifications well.
Key words: Boost LED driver controller; peak current mode; PWM dimming; BCD technology
参考文献(References):
［1］SAUERLANDER G, HENTE D, RADACHER H, et al. Driver electronics for LEDs［C］//Industry Applications Conference,2006,41st IAS Annual Meeting. Conference record of IEEE 2006,Floridai:［s.n］,2006:2621-2626.
［2］REDL R, NOVAK I. Instabilities in currentmode controlled switching voltage regulators［C］//PESC81 Record. Boulder:［s.n.］,1981:17-28.
［3］Modeling, Analysis and Compensation of the Current Mode Converter［M］. Unitrode Application Note,1999.
［4］FORGHANIZADEH H P, RINCONMORA G A. Current|sensing Techniques for DCDC Converters［C］//The 2002 45th Midwest Symposium on Circuits and System,2002:577-580.
［5］ERICKSON R W, MAKSIMOVIC D. Fundamentals of Power Electronics Second Edition ［M］. Norwell, Massachusetts: Kluwer Academic Publishers,2001.
［6］周志敏,周纪海,纪爱华.LED驱动电路设计与应用 ［M］.北京：人民邮电出版社, 2006.